Custom Products for the Digital Radio Amateur Enthusiast 		  Print this Page

Model DRA-100-DIN6
A Radio Interface for Digital Two-Way Radio Applications

What is it?
We've had some inquiries for a sound card device that has all of the cables on a common "side" and have the control functionality and a metal case. I've also had some who purchased our standard DRAs ask for adjustable VOX delay.

The DRA-100-DIN6 gives you DRA performance in a all alumunum case, along with VOX delay and a female Mini-DIN-6 radio connector.

Other than Hardware PTT keying, there are no advantages to this board (that we're aware of) for lower speed applications like FLDIGI, VARA HF, or 1200 baud packet. It certainly has much greater audio bandwidth and higher transmit audio levels required by some radios for higher speed applications like VARA FM Wide and HS SoundModem. Hardware PTT and VOX operates independently from transmit (TX) audio level, so you're never stuck between keying the radio and overdriving the transmitter.

The DRA-100 Series doesn't use transformers, therefore, the audio paths are much wider than other sound cards. A very high quality USB cable with ferrite RFI reduction is supplied with all DRA-100's. This cable provides additional RFI protection.

Like all DRA's, the Power LED is also the heartbeat (HB) indicator. A mechanical jumper configures the Power LED to flash or be on solid.

What's the design based on?
The DRA-100 Series is based upon our top-shelf DRA-80. Unlike our other VOX capable DRA's, this one includes a VOX delay (DLY) - control on the front panel. The delay range is from 0 to 1.5 seconds. The VOX gain control (R16) is not accessible from the outside, but most people just turn this pot up pretty far (50 - 60%) anyway. Of course, the DRA-100 has both Hardware PTT and VOX keying of the transmitter. VOX operation is configurable with jumpers just like the DRA-70 and '80, and can be (should be) disabled when using Hardware PTT preventing any possible VOX delay.

What led up to its design?
The desire to achieve the highest speed and provide the highest signal-to-noise ratio, in a all metal case.

Okay - really - how good is it?
The DRA-100 Series actually beats all other amplified DRAs in having the lowest noise. If you're looking for the ultimate FT4 or FT8 interface, this is it. Plus - it goes as fast as any other DRA easily reaching Level 13 in VARA FM Wide (licensed) with any high-speed data capable ham radio.

FCC Class B Certified.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.


Features List:


To order - you must acknowledge that you have read and understand and agree to the terms and conditions, limitations, and usefulness (or lack there of) of this product.

If you agree and want to continue, check the box below and place the order.


DRA-100-DIN-6 Ordering:
Please choose selection carefully!

DRA-100-DIN6
Unassembled Kit:

Case Color


DRA-100-DIN6
Assembled and Tested:

Case Color


DIN-6 Model Accessories:
DRAC-12 or DIN6-Shortie Radio Cable - Quantity can be changed in the cart.

Add a 6 foot DRAC-12 Radio Cable

Add a 3 foot DIN6-Shortie Radio Cable


Email Kevin Custer for support of this exciting product.

Product of Masters Communications, all rights reserved.
Specifications may change without notice.
FCC Class B Certified.
SignaLink USB is a trademark of Tigertronics.
No infringement is intended of the use of their trademarked name.
Images are property of Kevin Custer - W3KKC
Board layout by Kevin Custer - W3KKC
HTML February 14 2022, W3KKC All Rights Reserved!